Digital Denture Workflows

| 13 CE Credits Prerequisites: Utilizing 3D Printing for Efficient Everyday Dentistry OR Advanced CEREC Software Mastery are HIGHLY RECOMMENDED

This workshop will cover the reference denture workflow. We will take a poor fitting existing denture, do a physical wash impression, scan, and then design and print both a try in and final complete maxillary denture out of denture base and denture tooth resin.

We will also discuss techniques for immediate dentures and complete over natural and complete over complete workflows.

Participants Will Learn:

How to take an accurate denture wash impression
How to scan properly for a complete denture
inLab design for complete denture setup
How to print and process a try in denture and final denture base and teeth.

Cost:

$3,995 Doctors
$1,495 Team Members*

Credits:

13 CE Credits

Faculty:

Dan Butterman, D.D.S.
Meena Barsoum, D.M.D.

Location:

CDOCS Campus, Scottsdale, AZ
7201 E Princess Blvd
Scottsdale, AZ 85255
Map & Directions

CDOCS Campus, Charlotte, NC
13320 Ballantyne Corporate Place
Charlotte, NC 28277
Map & Directions

Dentsply Sirona Academy
60 Courtneypark Drive West
Unit 1
Mississauga, ON, L5W 0B3, Canada
Map & Directions

Questions?

Give us a call at 877.295.4276 or email us.

$3,995 Doctors

$1,495 Team Members*

Hands-On Workshops

CDOCS LLC is designated as an Approved PACE Program Provider by the Academy of General Dentistry. The formal continuing education programs of this program provider are accepted by the AGD for Fellowship/Mastership and membership maintenance credit. Approval does not imply acceptance bya state or provincial board of dentistry or AGD endorsement. The current term of approval extends from 10/1/2025 to 9/30/2029. Provider ID# 319544